Pre-charge/charge/discharge
The pre-charge/charge/discharge is used to provide pre-charge via and protect the battery pack from abnormalities such as overvoltage, overcurrent charging/discharging, overtemperature and external short-circuit. This can be implemented by using two low voltage FETs, which are controlled by the battery analog front end or the fuel gauge/ MCU.
Products
P-channel MOSFETs
CSD22205L—-8V, P channel NexFET™ power MOSFET, single LGA 1.2 mm x 1.2 mm, 9.9 mOhm, gate ESD protection
N-channel MOSFETs
CSD18534Q5A—60-V, N channel NexFET™ power MOSFET, single SON 5 mm x 6 mm, 9.8 mOhm
Battery protectors
BQ77216—Voltage and temperature protection for 3-s to 16-s cell Li-ion batteries with internal delay timer
BQ2962—Overvoltage Protection for 2-Series, 3-Series, and 4-Series Cell Li-Ion
BQ7718—Family 2-5S Overvoltage Protector with Internal Delay Timer
Monitoring/protection/cell-balancing/authentication
The monitoring/protection/cell-balancing/authentication is responsible for protecting, monitoring, balancing and authenticating the battery pack. The data that is monitored includes individual cell voltage and pack temperature. It also implements active/passive cell balancing of each battery cell inside the battery pack. Additionally it can control the charge and discharge FET present in the battery pack.
Products
Battery protectors
BQ77216—Voltage and temperature protection for 3-s to 16-s cell Li-ion batteries with internal delay timer
BQ2962—Overvoltage Protection for 2-Series, 3-Series, and 4-Series Cell Li-Ion
BQ7718—Family 2-5S Overvoltage Protector with Internal Delay Timer
BQ77207—3-series to 7-series cell Li-ion battery, internal delay timer, voltage and temperature protector
Battery authentication ICs
BQ2026—1.5K-Bit Serial EPROM with SDQ Interface
Previous: Electric power steering (EPS)